Winkhaus blueMatic EAV Instrucciones De Montaje página 163

Installation, Operating and
Maintenance Instructions
4.2.2 Programming
Each transponder set is supplied with 2 programming cards.
(programming card = green; delete-all card = red)
These cards are programmed to this reader / control unit.
Teach-in mode
Action
Pass the programmable
card over the antenna
Notice: If you do not swipe the transponder chip across the
antenna for a period of 5 seconds, the teach-in mode will be
stopped. The reader unit returns to operating mode.
Action
Pass all the transponder
chips to be authorised
in succession over the
antenna
Pass all the transponder
chips to be authorised
in succession over the
antenna
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
blueMatic EAV
Acoustic Signal
n n
short, every 0.5 seconds
Acoustic Signal
nnnnn
for about 1 second
no acoustic signal
(no more transponder
chips can be authorised
max. 250)
69 5044744
Programming card:
Set teach-in mode 
teach transponder chip
Result
Teach-in mode
active
Result
Transponder chips
authorised
no acoustic signal
(no more transponder
chips can be authorised
max. 250)
EN
4