Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
•
The client is responsible for preparing the location of the machine, the power supply,
water supply and drainage.
•
Check that the water supply and drain hoses and the power cord are not kinked,
pinched or crushed when you push the product into its place, after the installation or
cleaning procedures.
•
Ensure that the installation and electrical connections for the appliance are carried out
by an approved maintenance agent. The manufacturer shall not be liable for damage
resulting from work carried out by unauthorized personnel.
•
Prior to installing, check whether the product has any defects. If you identify any, do
not install the appliance. Damaged products are a safety risk.
Removing the packaging reinforcements
Tilt the washing machine backwards to remove the packaging reinforcement. Remove
the packaging reinforcement by pulling on the security ribbon. Do not perform this
operation on your own.
44
Removing the transit bolts
Four transit bolts are screwed into the rear of the washing machine in order to guarantee
it is transported in complete safety.
IMPORTANT: the transit bolts serve to prevent any internal damage during transport;
these must be removed before operating the washing machine! If not, the appliance will
be damaged, and this is not covered by the warranty.
1.
Unscrew the transit bolts by turning them anti-clockwise using an appropriate
spanner.
2.
Remove the 4 bolts and washers from their housing by pulling them out with pliers.
3.
Put them in a safe place so they can be reused if needed.
4.
Plug the holes with the plastic caps provided.
CAUTION: to transport the appliance, always make sure that the transit bolts are
correctly in place!
NOTE: if you wish to transport the washing machine, reinsert the transit bolts (in reverse
order).
Installation location
•
Place the appliance on a flat, rigid floor. Never install your appliance on a carpet or
rug: air must be able to circulate freely around the appliance.
•
When the washing machine and tumble drier are stacked, place them on a flat, solid
floor with a sufficient load-bearing capacity.
•
The appliance must be placed on a resistant floor (that can bear the weight of the
appliance), the surface of which is clean and dry (to prevent the appliance sliding).
•
Be sure not to place the appliance on its power cord.
•
Ensure that the washing machine is not touching the wall or surrounding furniture.
•
Do not install your appliance in a room where the temperature is 0°C or below. For
optimum operation, install your appliance in a living room.
45
Publicidad
