Publicidad
Idiomas disponibles
Idiomas disponibles
Caution! The washing machine may contain water at 90°C. As a result, the filter
must only be cleaned after the hot water inside is cooled, in order to prevent any
risk of burns.
1.
Stop the washing machine and unplug the power cord.
2.
Remove the cover.
3.
Place a container under the cover to collect the residual water.
Important: if the circuit is blocked, there may be a lot of water!
4.
Unscrew the filter slightly so that the water runs.
5.
When the water has run out, remove the filter completely from its housing in order
to clean it. Remove any foreign bodies.
6.
Replace the filter by screwing it up, then close the cover again.
Caution: If you do not reinstall the filter correctly, the water will run out of the
washing machine!
74
Troubleshooting guide
Incorrect operation may be due to a minor problem that you can solve yourself using
the instructions below. Please carry out the following checks before calling your store's
after-sale department:
Problems
Possible Causes
The washing machine does
The power cord is not
not start.
plugged into the wall socket.
The fuse may have blown or
is defective.
There may be a power cut.
No buttons work.
The program selector is in
the "OFF" position.
The door is closed
incorrectly.
The child lock is on.
What To Do
Check the plug.
Check the fuse.
Check the electricity
supply.
Choose your program
with the program
selector, then press the
button to start the
program.
Close the door
correctly. You should
hear (sic)
Check that the control
panel is unlocked (the
child lock symbol must
be out).
75
Publicidad
