SMA EV CHARGER 7.4 Manual De Operación página 17

SMA Solar Technology AG
Digital input X1301 can be used to connect a fast stop switch to control the charging station by the
grid operator or a key switch or RFID card reader to enable charging.
SMA Smart Connected
SMA Smart Connected is the free monitoring of the product via the SMA Sunny Portal. Thanks to
SMA Smart Connected, the operator and qualified person will be informed automatically and
proactively about product events that occur.
SMA Smart Connected is activated during registration in Sunny Portal. In order to use SMA Smart
Connected, it is necessary that the product is permanently connected to Sunny Portal and the data
of the operator and qualified person is stored in Sunny Portal and up-to-date.
4.4 LED Signals
The LEDs indicate the operating state of the product.
LED signal
The green LED is flashing
slowly (2 seconds on and
2 seconds off)
The green LED is flashing
fast: 0.5 s on and 0.5 s off
The green LED is glowing
The green LED is pulsing
The green LED is off
The red LED is glowing
Red LED flashing
Operating manual
Explanation
Waiting for start conditions
The conditions for charging operation are not yet met. As soon as
the conditions are met, the EV Charger will start charging operation.
Software update
The product is carrying out a software update.
Charge mode
The EV Charger charges the vehicle at more than 90% of its nominal
power.
Charge mode
The EV Charger is equipped with a dynamic power display via the
green LED. Depending on the power, the green LED pulses fast or
slow.
The EV Charger does not perform any charging process.
Event occurred
If an event occurs, a distinct event message and the corresponding
event number will be displayed in addition on the product user inter-
face or in the communication product (e.g. Sunny Home Manager).
Charging mode was interrupted by vehicle.
If this event occurs, the vehicle has interrupted the charging process.
Corrective measures:
• Opening and closing of the vehicle by radio remote control.
• Remove the charging cable from the vehicle and then
reconnect the charging cable to the vehicle.
• Check and if necessary adjust the settings in the vehicle's user
interface.
4 Product Overview
EVCxx-10-BE-en-11 17