SMA EV CHARGER 7.4 Manual De Operación página 7

SMA Solar Technology AG
2 Safety
2.1 Intended Use
The SMA EV Charger is an AC charging station that is designed for unidirectional charging of a
vehicle. The SMA EV Charger along with the Sunny Home Manager 2.0 makes an intelligent
charging station. If the SMA EV Charger is operated without Sunny Home Manager 2.0, the modes
for intelligent charging are not available.
The product must only be used as stationary equipment.
The product is suitable for indoor and outdoor use.
The EVC7.4-1AC-10 must not be used in industrial environments.
The product must be tested in fast charging mode according to IEC 61851 before its first charging
operation using a suitable measuring device for charging stations.
All components must remain within their permitted operating ranges and their installation
requirements at all times.
The product must only be used in countries for which it is approved or released by SMA Solar
Technology AG and the grid operator.
Use SMA products only in accordance with the information provided in the enclosed
documentation and with the locally applicable laws, regulations, standards and directives. Any
other application may cause personal injury or property damage.
Alterations to the SMA products, e.g., changes or modifications, are only permitted with the express
written permission of SMA Solar Technology AG. Unauthorized alterations will void guarantee and
warranty claims and in most cases terminate the operating license. SMA Solar Technology AG
shall not be held liable for any damage caused by such changes.
Any use of the product other than that described in the Intended Use section does not qualify as
appropriate.
The enclosed documentation is an integral part of this product. Keep the documentation in a
convenient, dry place for future reference and observe all instructions contained therein.
This document does not replace any regional, state, provincial, federal or national laws, regulations
or standards that apply to the installation, electrical safety and use of the product. SMA Solar
Technology AG assumes no responsibility for the compliance or non-compliance with such laws or
codes in connection with the installation of the product.
The type label must remain permanently attached to the product.
2.2 IMPORTANT SAFETY INSTRUCTIONS
Keep the manual for future reference.
This section contains safety information that must be observed at all times when working.
The product has been designed and tested in accordance with international safety requirements. As
with all electrical or electronical devices, there are residual risks despite careful construction. To
prevent personal injury and property damage and to ensure long-term operation of the product,
read this section carefully and observe all safety information at all times.
Operating manual EVCxx-10-BE-en-11
2 Safety
7