SMA EV CHARGER 7.4 Manual De Operación página 27

SMA Solar Technology AG
Figure 11: Recommended clearances(Dimensions in mm)
5.2 Mounting the product
Additionally required material (not included in the scope of delivery):
• 3 stainless steel hexagon head wood screws (AF 10, diameter 6 mm), screw length must be
suitable for the support surface and the weight of the product (fastening bracket thickness:
4 mm)
• 1 washer (diameter: 6 mm)
• Where necessary, 3 screw anchors suitable for the support surface and the screws
Risk of injury due to weight of product
Injuries may result if the product is lifted incorrectly or dropped while being transported or
mounted.
• Wear suitable personal protective equipment for all work on the product.
Procedure:
1. Mark the position of the drill holes. Align the markings horizontally.
2. Drill the holes.
3. Insert screw anchors into the drill holes if the support surface requires them.
4. Insert the screws until there is at least 6 mm clearance between the screw head and the
support surface.
Operating manual
200 100
CAUTION
5 Mounting
50
EVCxx-10-BE-en-11 27