SMA EV CHARGER 7.4 Manual De Operación página 66

13 Procedure for Receiving a Replacement Device
13 Procedure for Receiving a Replacement Device
Under fault conditions, the product may need to be replaced. If this is the case, you will receive a
replacement device from SMA Solar Technology AG. If you received a replacement device,
replace the defective product with the replacement device as described below. The replacement
device can be equipped with a transport lid. The transport lid must be exchanged for the enclosure
lid of the defective product. The connection cap and charging cable are not replaced. Use the
connector cap and charging cable of the defective product.
Procedure:
1. Decommission the defective product (see Section 12, page 62).
2. Mount the replacement device and make the electrical connections as described in this
document.
3. If the enclosure lid of the replacement device is a
transport lid (see information on the enclosure lid),
replace the transport lid of the replacement device
with the enclosure lid of the defective product.
Tighten the screws of the enclosure lid in the order
shown (TX25, torque: 6 Nm ± 0.3 Nm). Then
tighten the first screw again.
4. Commission the replacement device (see Section 7.2, page 40).
5. Establish a connection to the user interface (see Section 8.1, page 44).
6. Configure the product using the commission assistant (see Section 7.4, page 43).
7. If the defective product had been registered by a communication product, replace it with the
new product in the communication product (see operating manual of communication product).
8. Pack the defective product in the packaging of the replacement device and arrange with SMA
Solar Technology AG for it to be picked up.
66 EVCxx-10-BE-en-11
SMA Solar Technology AG
1
3
4
2
Operating manual
4x