SMA EV CHARGER 7.4 Manual De Operación página 37

SMA Solar Technology AG
5. Trim unused insulated conductors flush with the cable sheath.
6. If necessary, fit the conductors with bootlace ferrules.
7. Pass the connecting cable through the cable gland for connecting a signal source to the digital
input.
8. Feed the connection cable through the enclosure opening for connecting a signal source to the
digital input into the product.
9. Guide the 2 ferrites from the scope of delivery over
the cable.
10. Connect the conductors to the terminal block
supplied. Observe the pin assignment. If only the
fast-stop function is to be used, connect the
conductors only to the 2-pole terminal block. If all
functions are to be used, connect the conductors to
the 5-pole terminal block.
11. Plug the terminal block into the socket for connecting
a digital signal source.
12. Ensure that the conductors are plugged into the terminal points tightly by pulling slightly on the
conductors.
13. Tighten the cable gland hand-tight.
Operating manual
6 Electrical Connection
2
1
2
1
EVCxx-10-BE-en-11 37