Publicidad
Idiomas disponibles
Idiomas disponibles
Water supply hose connection
Warning
Do not kink, crush, modify or repair the water supply hose.
-
Make the connection manually, do not use tools. Check the connection is optimal.
-
Connection between the washing machine connector and the water supply hose.
Align the curved part of the hose and the washer connector (inlet valve) on the back of
-
the product as shown in figure 7.
Tighten the compression nut by turning clockwise.
-
Connection between a screw tap and the water supply hose
Screw tap and water supply hose.
Align the other end of the water supply hose and the threaded tap and tighten the
compression nut tightly by turning clockwise. Check figure 8 for reference.
Drain hose
Note
Do not kink or protract the drain hose.
-
Position the drain hose properly, at 60-90 cm from the floor.
-
There are two ways to place the end of the drain hose:
In a drainpipe. It is recommended to use a vertical tube. Fig. 9
-
In a sink's drainpipe, over the trap. Fig. 10
-
If the washing machine has a drain hose bracket (depending on the model), it can also be
installed on a sink or a tank, as indicated next.
Warning
When installing the drain hose, fix it properly with a rope or a clamp. If drain hose is too long,
do not force it into washing machine as it will cause abnormal noises.
Acoustic sponges (depending on model)
Warning
Be sure to assemble the acoustic sponges, as they can reduce the noise caused by the
washing machine while it is running.
Place a soft material, such as foam or towels, between the base of the washing machine
-
and the floor for protection.
BOLERO DRESSCODE 740/840/940 BI INVERTER A
ENGLISH
77
Publicidad
