Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Gently lift the washing machine on one side and stick the longer sponges on the longer
-
bottom edges of the washing machine on its base. Do the same to adhere the shorter
sponges to the shorter bottom edges. Fig. 11
4. OPERATING INSTRUCTIONS
Note
-
Please make sure the appliance is properly installed before operation.
-
Before washing the clothes for the first time, the product shall be operated in one round
of the whole procedures without the clothes inside.
-
All washing machines are thoroughly checked before leaving the factory and undergo
quality control. There may be a small amount of residual water in the drum. To remove it,
as well as to neutralise possible odours, it is recommended to clean the drum before the
first use. You can run a Drum Clean programme or use another washing programme at a
temperature of 90°C without laundry and detergent.
Calibration
It is advisable to calibrate the washing machine before its first use in order to get the best
-
performance from it.
The device is able to detect the amount of laundry in the drum. Calibration optimises
-
product performance by minimising water and energy consumption.
To perform the calibration, follow the steps below:
-
Remove any objects from the drum and close the door.
-
Plug the power cord into the outlet.
-
Switch on the machine and press the Delay Start and "Speed" buttons simultaneously for
-
about 10 seconds until the control panel displays "t19".
Next, to start the washing machine, press the Start/Pause button. The drum will start to
-
rotate slowly, and the display will show different numbers, when it shows a steady figure
the washing machine is calibrated, you can turn the device off.
Start of washing
Before washing
Plug the appliance into a power supply.
-
Open the water supply tap.
-
Load the washing machine with the laundry.
-
Close the door.
-
Add detergent (and softener if necessary) in the dispenser tank.
-
78
BOLERO DRESSCODE 740/840/940 BI INVERTER A
Publicidad
