cecotec BOLERO DRESSCODE 10800 INVERTER A Manual De Instrucciones página 11

SAFETY INSTRUCTIONS
Read these instructions thoroughly before using the device.
Keep this instruction manual for future reference or new
users.
- Ensure that the mains voltage matches the voltage
specified on the device rating label and that the plug is
earthed.
- If the power cord is damaged, it must be replaced by the
official Cecotec Technical Support Service or by a similarly
qualified person to prevent hazards.
- This appliance is for indoor use only.
- Make sure the device is installed in places where the
temperature is above 0 ºC.
- The device is not designed for built-in installation.
- Use the hose set supplied with the appliance. Do not reuse
old hoses.
- Check hose connections regularly to ensure that no water
leaks out.
- Do not use the appliance if parts are missing or defective or
if the power cord or plug is damaged.
- Do not use the appliance until you are sure that it is
installed in accordance with the instructions provided in
this manual and all water, drain, electrical and grounding
connections comply with all applicable local regulations
and/or other requirements.
- Before carrying out any maintenance or cleaning in the
device, unplug the appliance from the mains.
- As a safety measure, we advise you to unplug the appliance
and cut the water supply after every use. Maximum water-
inlet pressure: 1 MPa. Minimum water-inlet pressure: 0.03
MPa.
BOLERO DRESSCODE 10800 INVERTER A/ STEEL A
11