ENGLISH
Wash cycle does not
start
No water or detergent
enters the drum. Error
"E02" appears on the
screen
Water discharge when
the programme starts
The water level is too
low when the machine is
washing
Overfilling of water
during operation of the
wash cycle
Too much foam in the
drum or foam overflows
from the detergent
dispenser
The high-speed spin
must be repeated many
times (spinning)
BOLERO DRESSCODE 10800 INVERTER A/ STEEL A
124
The door is not closed properly.
The START/PAUSE button has not been pressed.
The water tap has not been turned on to allow water to flow
into the appliance.
A delay end function has been configured.
Water supply hose is kinked or bent.
The water supply hose is not connected to the water supply.
The water pressure is too low.
The water tap has not been opened to allow water to flow into
the machine.
There is no water supply in the dwelling.
The mesh filter in the water supply hose and/or the water
inlet valve is/are blocked.
Tap and/or water supply pipe is/are frozen.
The START/PAUSE button has not been pressed.
There is already enough water in the drum.
This is not an issue. Do not open the door to pour water
directly into the drum before the programme is run, otherwise
the machine may discharge the water that was poured into
the drum when the programme was started.
This is not an issue. The water consumption in the wash cycle
of this appliance is relatively small, the water level in the wash
cycle is lower than that of other types of washing machines.
If the water level drops, the machine will automatically
recover the water.
When the amount of laundry to be washed is too large, the
appliance can automatically fill the water several times during
the operation of the wash cycle.
The detergent is not suitable for machine washing (must show
the text "for washing machines" or "hand and machine wash"
or similar).
Too much detergent was used; less detergent is required in
soft water.
Due to different types and materials of laundry, the load
balancing system of the appliance may wobble and scatter
the laundry many times to extend the spin time. This is a
normal phenomenon, not an incidence of the machine.