cecotec BOLERO DRESSCODE 10800 INVERTER A Manual De Instrucciones página 115

Delay End
After selecting the wash programme, press the Delay End button repeatedly to set the
-
programme end time, which is incremented in one-hour intervals, up to a maximum of
24 hours. After selecting the desired wash programme, but before pressing the START/
PAUSE button, press the Delay End button until the desired time is displayed, e.g. 8h, with
the Delay End indicator light on.
NOTE: the cycle time is included in the set deferred end time.
Example of a cycle time of 1 hour and 30 minutes and a delay end time of 8 hours.
-
8 h is shown on the display and a countdown (approx. 6 hours and 30 minutes) until the
-
wash cycle starts, then the cycle duration 1: 30 is shown and starts. The total time is
approximately 8 hours.
The way to cancel the deferred termination function is as follows:
-
Turn the wash cycle knob to reset the wash cycle. The Delay End indicator light will go out
-
and the display will stop showing the delay completion time.
NOTE:
The actual end time of the wash cycle may be different from the set delay end time,
depending on multiple factors such as water supply pressure, drainage, type of laundry,
water temperature, as well as other conditions.
Steam washing
Press the STEAM button to add a steam wash process after the last water drain stage of the
selected (or ongoing) wash cycle and before the last spin. In the steam washing process, the
machine generates a large amount of high temperature steam that penetrates deep into the
fabric, improving the softness and elasticity of the laundry and, at the same time, eliminates
odour and refreshes the laundry. After the steam washing process, the machine enters the
final stage of draining and spinning.
Child Lock
1. The setting of the child lock function can prevent malfunctions or unwanted incidents.
2. During operation, press and hold the SPEED button for approximately 3 seconds to set or
cancel the child lock function.
3. After setting the child lock function, its indicator light comes on, the door cannot be
opened and the control panel is locked, the buttons remain inactive, as well as the wash
cycle selector (the indicator light below the power symbol is on
be switched off by turning the wash cycle selector to its OFF position, the indicator light
below the power symbol will go out and the device will stop operating. If the machine is
switched off, the child lock function will be cancelled.
BOLERO DRESSCODE 10800 INVERTER A/ STEEL A
ENGLISH
). The machine can only
115