Descargar Imprimir esta página

TWINCA ES-500 Manual De Operaciones página 42

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 180
The most important points related to the use and safety of the machine are shown on the machine with pictograms.
Charging
Electricity must be treated with great respect. Avoid electric shock and explosions.
The power cord is short. Avoid pulling the power cord. Connect an extension cord when charging the machine's
batteries. The machine has a built-in charger that automatically shuts off, preventing the batteries from becoming
overcharged.
The LED light will give a short intermittent blink if the battery has not been charged for a long time, or if the
battery voltage has dropped to a very low level. The light illuminates red in the event of an error and illuminates
green when fully charged.
All charging of the machine must take place in a dry and ventilated room with access to a foam or CO2 extinguisher.
Do not use tools there creates sparks near the machine during charging. Never use a wet, defective or worn
supply cable and always check that all electronics are properly connected.
The machine is equipped with a multi-input charger so that the
machine can be connected to all power sources between 110V
and 230V.
The charger plug is located under the display.
Charging time may vary depending on the battery and battery
size of the selected model. The batteries are categorized as a wear
part and may be replaced during the life of the machine. When
replacing batteries to other than the original ones, different terms
and conditions of use may apply.
The machine must not be used during charging. A full charge of the original battery takes a minimum of 6 hours.
Batteries
The machine is 100% electrically powered. The machine is powered by two batteries that at full charge, normal
driving patterns and temperature conditions, it can hold power for an entire working day (8 hours). The battery
that comes with the machine is a maintenance-free lead-acid battery.
Battery Leak procedure: Wear acid-resistant clothing, boots, gloves, and face visor. Stop the leak and absorb
the acid with e.g., granules or shavings if possible, neutralize with soda, sodium, pulverized lime etc. Never
drain acid into the nature or sewer. For more information about the battery please contact the manufacturer.
Optimal use of the battery
Discharge: -15°C - 50°C (5°F - 122°F)
Charging:
0°C - 40°C (32°F - 104°F)
Storage:
-15°C - 40°C (5°F - 104°F)
TWINCAES5008001-EN
38

Publicidad

loading

Este manual también es adecuado para:

Es-500 slimEs-800