Craftsman 919.195411 Manual Del Propietário página 22

9. Apply pipe sealant tape to the
nipple.
10. Assemble the regulator and
orient as shown in previous
figure.
NOTE: Arrow indicates flow of
air. Make sure it is pointing in the
direction of air flow.
ReguBator .......... "T'_
11. Reapply pipe sealant to outlet
pressure gauge, tank pressure
gauge, and quick connect.
12. Reassemble outlet pressure
gauge,tank pressure gauge,
and quick connect. Orient
outlet pressure gauge and tank
pressure gauge to read correctly.
Tighten quick connect with
wrench.
13. Rotate pressure switch assembly
into correct position.
14. Replace console cover and
regulator ring.
15. Replace handle. Refer to
"Handle Assembly" paragraph in
the "Assembly" section.
To Replace Belt
Risk of Unsafe
Operations, Serious
injury or damage may occur if
parts of the body or moose items
get caught inmoving parts. Never
operate the unit with the belt
guard removed. The beretguard
should be removed only when the
compressor is unplugged.
1. Place the On/Auto/Off lever in
the "Off" position.
2. Unplug compressor.
3. Remove the front of the beIt
guard by disengaging the snaps.
insert a fiat bladed screwdriver at
each snap location and pry the
beltguard apart.
4. Loosen the wing nut on hold
down pIate and tiIt motor
to allow for easy removal or
instalIation of the belt.
5. Remove belt.
6. Replace belt. NOTE: The belt
must be centered over the
grooves on the flywheel and
motor pulley.
7. Turn the wing nut on the hold
down plate until it makes contact
with the washer, ptus one
additional turn.
8. Replace the belt guard.
A09713 22-ENG