Craftsman 919.195411 Manual Del Propietário página 24

t,® = ®® e I
Performing repairs may expose vomtage sources, moving
parts, or compressed air sources. Personal injury may
occur. Before servicing: Unplug or disconnect electrical suppmy to the air
compressor, bleed tank of pressure, and allow the air compressor to cool.
PROBLEM CAUSE CORRECTION
Excessive
tank pmssure
-sd_y valve
pops off.
Air leaks at
fittings.
Air leaks at or
inside check
valve
Air leaks at
pressure switch
release valve.
(if equipped)
Air leaks in air
tank or at air
tank welds.
Pressure switch does
not shut off motor when
compressor reaches "cut-
out" pressure.
Pressure switch "cut-out"
too high.
Tube fittings are not tight
enough.
Check valve seat damaged.
Defective pressure switch
release valve.
Defective air tank.
Move On/Auto/Off lever to
the "Off" position, if the air
compressor does
not shut off, contact a
Trained Service Technician.
Contact a Trained Service
Technician.
Tighten fittings where air
can be heard escaping.
Check fittings with soapy
water solution. DO NOT
OVERTIGHTEN.
A defective check valve
results in a constant air leak
at the pressure release valve
when there is pressure in the
tank and the compressor
is shut off. Replace check
valve. Refer to the "To
Replace or Clean Check
Valve" in the "Service and
_ustments" section.
Contact a Trained Service
Technician.
Air tank must be replaced.
Do not repair the leak.
Risk of
Bursting,
Do not drill into, weld or
otherwise modify air tank
or it will weaken. The tank
can rupture or expmode.
Air leaks Leaking sea!. Contact a Trained Service
between head Technician.
and valve plate.
A09713 24- ENG