Craftsman 919.195411 Manual Del Propietário página 25

PROBLEM
Pressure reading
on the outlet
pressure gauge
(if equipped)
drops when an
accessory is
used.
Air leak from
safety valve.
Compressor is
not supplying
enough air
to operate
accessories.
CAUSE
it is normal for "some"
pressure drop to occur.
Possible defect in safety
valve.
Prolonged excessive use
of air.
Compressor is not large
enough for air requirement.
Hole in hose.
Check valve restricted.
Air leaks.
Restricted air intake filter
Loose belt.
Restricted air Dirty air filter.
intake.
Regulator knob Damaged regulator.
has continuous
air leak.
Regulator will Damaged regulator.
not shut off air
outlet.
25- ENG
CORRECTION
if there is an excessive amount
of pressure drop when the
accessory is used, adjust the
regulator as instructed in the
Operation section.
NOTE: Adjust the regulated
_ressure under flow conditions
while accesory is being used).
Operate safety valve manually
by pulling on ring. if valve still
leaks, it should be replaced.
Decrease amount of air usage.
Check the accessory air
requirement, if it is higher than
the SCFM or pressure supplied
by your air compressor, you
need a larger compressor.
Check and replace if required.
Remove and clean, or replace.
Tighten fittings.
Clean or replace air intake
filter. Do not operate the
air compressor with the
filter removed. Refer to the
"Air Filter" paragraph in the
"Maintenance" section.
Loosen wingnut and then
tighten wingnut until it contacts
the washer, plus one turn.
Clean or replace. See "Air
Filter" paragraph in the
"Maintenance" section.
Replace.
Replace.
A09713