Home Decorators Collection 52060 Manual De Instrucciones página 12

Assembly - Attaching the Light Kit
1
Installing the light kit pan
□
Remove one screw (FF) from the black bracket below the fan
motor assembly (E), and loosen but do not remove the other
two screws.
□
Push the light kit pan (G) up to the fan motor assembly (E) so
that the two loosened screw heads fit into the keyhole slots.
Turn the light kit pan (G) clockwise.
□
Re-install the screw (FF) that was removed in the first step.
□
Make sure all the screws are firmly tightened.
2
Attaching the light kit fitter assembly
□
Remove one screw (TT) from the light kit pan (G), and loosen,
but do not remove, the other two screws.
□
Connect the wires from the light kit fitter assembly (H) to
the wires from the fan motor assembly (E) by connecting the
molded adaptor plugs together. Carefully tuck all wires and
splices into the switch cup.
□
Push the light kit fitter assembly (H) up to the light kit pan
(G) so that the two loosened screw heads fit into the keyhole
slots. Turn the light kit fitter assembly (H) clockwise to secure.
□
Re-install the screw that was removed in the first step.
□
Make sure all the screws are firmly tightened.
3
Installing the shatter-resistant shade
WARNING: Do not overtighten when installing the shatter-
resistant shade into the light kit. Allow the shatter-resistant
shade to cool completely before removing.
□
Place the shatter-resistant shade (I) into the light kit pan (G),
aligning the three flat areas on the top of the flange of the
shatter-resistant shade (I) with the three raised dimples in the
light kit pan (G). Turn the shade clockwise until it stops.
G
TT
G
12
G
FF
H
I