Home Decorators Collection 52060 Manual De Instrucciones página 7

Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the magnetic canopy bottom cover (JJ) from the
canopy (C) by pulling it off.
□
Loosen the two canopy screws (EE) located in the bottom of
the mounting bracket (A).
□
Turn the mounting bracket (A) counterclockwise and lift it up to
remove the mounting bracket from the canopy (C).
3
Routing the wires
NOTE: The fan comes with 12 in. lead wires for use with
the provided 6 in. ball downrod assembly (B). If you wish
to use a longer downrod, attach the 3-pin extension wire
(L) and 2-pin extension wire (M) to the fan by connecting
the molded adaptor plugs from the extension wires to the
3-pin and 2-pin adaptor plugs from the fan.
□
Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the
center of the canopy bottom cover (JJ).
□
Make sure the opening of canopy (C) is on top and insert the
ball/downrod (B) through the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
2
□
□
A
E
EE
C
JJ
7
Attaching the fan blades to the fan
motor assembly
Attach the blade (F) to the the fan motor assembly (E), align the
four screw holes in the blade with the screw holes above and
under the motor assembly (E), and secure the blade with blade
arm screws (AA).
Repeat this step for the remaining the blades.
AA
C
JJ
D
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
AA
F
E