GYS GYSFLASH 30.24 HF Manual Del Usuario página 18

Submenu:
• Languages:
This menu enables to select the language (use the arrows to change the
language).
• Automatic restart:
Automatic restart only works with «Showroom» , «Charge» and «Power
Supply» Mode. This feature enables the charger to restart automatically
and to restart charging after a cut in power.
To activate the «Automatic restart» feature « Configuration | Restart :
ON ».
• Lock Showroom:
To lock the device in Showroom Mode. (To avoid misuse)
To activate the «Lock Showroom» feature « Configuration | Lock
Showroom : Y ».
Shortcut to Lock Showroom:
The «Lock Showroom» feature can be activated without accessing the configuration menu.
• Turn off the device (main switch in OFF position)
• Push the MODE key
• Turn on the switch, while the MODE key is still pressed. Within 3s the display will show «GYS-
FLASH 30.24 HF Vx.x»
• Hold the MODE key until the screen displays «lock showroom: Y»
• Charge type:
It is possible to choose the type of charge wanted:
- Automotive charge (automo.) to charge starter batteries.
- Traction charge (traction) to charge traction batteries.
• Cables check:
This mode must be used each time the cables are changed. This charger can be fitted with cables up to 2x8m
in 16mm².
OK : The calibration was successful.
FAIL : A problem occurred during the calibration. In this case, the calibration is reset to the factory setting.
Check that the cables are in good condition and properly put in short-circuit and repeat the procedure.
• Advanced Menu (code 1-9-6-4) :
This menu is intended for expert user only.
To access this menu, enter in the code («Select» key to change the digit selection and «Start/Stop» key to confirm
the code).
For more details, see next page.
• Reset Memory (code 1-9-6-4) :
This menu is intented to factory reset the charger settings by
entering the code above. Any personal parameters are deleted.
18
GYSFLASH 30.24 HF
CONFIGURATION MODE
SETTINGS
English
SETTINGS
restart: ON
SETTINGS
lock showroom: N
SETTINGS
charge: automo.
SETTINGS
Cables Testing:
Press START
SETTINGS
Advanced Menu:
Press START
SETTINGS
Reset Memory:
Press START
RESET MEMORY
0
RESET MEMORY
1
...
Code: 0000
9
RESET MEMORY
Change the
Error Code Code NOK code number
Code OK
(1964)
Display 1s
RESET MEMORY
Code OK
Yes
RESET MEMORY
Reset all ?
No
EN
English
Francais
Deutsch
Nederlands
Espanol
Portugues
Italiano
Russian
...
ON
OFF
Y (yes)
N (no)
automo.
traction
Cables testing
Advanced menu
Reset Memory
MODE