Descargar Imprimir esta página

Aiwa NSX-A508 Manual De Instrucciones página 2

Sistema estereo con reproductor de discos compactos
Ocultar thumbs Ver también para NSX-A508:

Publicidad

Idiomas disponibles

Idiomas disponibles

"CAUTION:TO
REDUCE
THE
RISK OF
ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE
PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL."
Owner's record
For your
convenience,
record
the model
number
and serial
number
(you will find them on the rear of your set) in the space
provided
below. Please refer to them when you contact your Aiwa
dealer
in case of difficulty.
I
Model No,
I
Serial
No. (Lot No.)
\
I
CX-NA508
I
I
SX-NA502
SX-R275
Read the Operating
Instructions
carefully
and completely
before
operating
the unit.
Be sure to keep the Operating
Instructions
for future
reference.
All warnings
and cautions
in the Operating
Instructions
and on the unit should
be strictly
followed,
as well
as the safety suggestions
below.
Installation
1
2
3
4
5
6
7
8
Water and moisture — Do not use this unit near water, such
as near a bathtub, washbowl, swimming pool, or the like.
Heat —
Do not use this unit near sources
of heat, including
heating vents, stoves, or other appliances
that generate
heat.
It also should
not be placed
in temperatures
less than 5°C
(41 'F) or greater than 35°C (95"F).
Mounting
surface
— Place the unit on a flat, even surface.
Ventilation
— The unit should
be situated
with adequate
space
around
it so that proper
heat ventilation
is assured.
Allow 10 cm (4 in.) clearance
from the rear and the top of the
unit, and 5 cm (2 in.) from each side.
- Do not place the unit on a bed, rug, or similar
surface
that
may block the ventilation
openings.
- Do not install the unit in a bookcase,
cabinet,
or airtight
rack
where ventilation
may be impeded.
Objects and liquid entry — Take
care that objects
or liquids
do not get inside the unit through
the ventilation
openings.
Carts and stands ——
When placed
or mounted
on a stand or cart, the
unit should
be moved with care.
Quick stops,
excessive
force, and
m
.L
uneven
surfaces
may cause
the
Y
A-.
unit or cart to overturn
or fall.
Condensation — Moisture may form on the CD pickup lens
when:
-
The unit is moved from a cold spot to a warm spot
- The heating
system
has just been turned
on
- The unit is used in a very humid room
- The unit is cooled
by an air conditioner
When
this unit has condensation
inside,
it may not function
normally.
Should
this occur,
leave the unit for a few hours,
then try to operate
again.
Wall or ceiling mounting
—The
unit should not be mounted
on a wall
or ceiling,
unless
specified
in the
Operating
Instructions.
Electric Power
1 Power sources — Connect this unit only
to power sources
specified
in the Operating
Instructions,
and as marked
on the
unit.
2
Polarization — As a safety feature, some units are equipped
with polarized AC power
plugs which
can only be inserted
one way into a power outlet.
If it is difficult
or impossible
to
insert the AC power plug into an outlet, turn the plug over and
try again.
If it still does not easily insert into the outlet, please
call a qualified
service
technician
to service
or replace
the
outlet.
To avoid defeating
the safety feature
of the polarized
plug, do not force it into a power outlet,
3
AC power cord
- When disconnecting the AC power cord,
pull it out by the
AC power plug.
Do not pull the cord itself.
- Never
handle
the AC power
plug with wet hands,
as this
could result in fire or shock.
- Power cords should be firmly secured to avoid being severely
bent, pinched,
or walked
upon. Pay particular
attention
to
the cord from the unit to the power outlet.
- Avoid
overloading
AC power
plugs
and extension
cords
beyond
their capacity,
as this could result in fire or shock.
1
ENGLISH

Publicidad

loading