VONROC PD501AC Traducción Del Manual Original página 10

EN
lockable. This prevents the power tool from
storage damage, and from being operated by
untrained persons.
Immediately switch off the machine when:
• Interruption in the mains plug, mains lead or
mains lead damage.
• Defect switch.
• Smoke or stench of scorched isolation.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
The machine is provided with a zero voltage
switch. After the tension drops the machine
will not start to run automatically for safety
reasons. The machine must be switched on
again.
Replacing cables or plugs
Immediately throw away old cables or plugs when
they have been replaced by new ones. It is dange-
rous to insert the plug of a loose cable in the wall
outlet.
If the replacement of the supply cord is necessary,
this has to be done by the manufacturer or his
agent in order to avoid a safety hazard.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
always unwind the reel completely.
2. MACHINE INFORMATION
Intended use
The product is suitable for drilling in wood, metal,
ceramic and plastic using the appropriate applicati-
on tools. It is designed for use in private environ-
ments, for example at home. Food and harmful
materials may not be processed with the machine.
10
. When using a cable reel
2
The drill chuck is designed for use with drill bits
and tools with a cylindrical shaft and a diameter
of 1.5-13 mm. The machine is intended for use by
adults only. The equipment is to be used only for its
prescribed purpose. Any other use is deemed to be
a case of misuse, and the warranty will be voided.
The manufacturer shall not be liable for any dama-
ge or injuries of any kind caused as a result of this.
TECHNICAL SPECIFICATIONS
Voltage
Frequency
Power input
Protection class
No load speed
Chuck capacity
Max drilling depth (spindle travel) 80mm
Distance between chuck and
base
Base dimensions
Max drilling diameter
Wood
Steel
Laser specifications:
Class
Wavelength
Output
Weight
Sound pressure level LPA
Sound power level LWA
* S1, continuous duty operation mode.
* S6, continuous operation periodic duty. Identical
duty cycles with a period at load followed by a
period at no load. Running time 6 minutes.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
230 V~
50Hz
720W S1, 900W S2 6min
II
Gear 1: 220-880/min.
Gear 2: 650-2550/min.
1.5-13mm
85-300mm
340*300*40mm
Ø40mm
Ø13mm
2
650 nm
< 1 mW
7,8 kg
79.7 dB(A) K=3 dB(A)
90.7 dB(A), K=3dB(A)
WWW.VONROC.COM