hillvert HT-MD-300A Manual De Instrucciones página 134

The power trackbarrow has the steering levers on the handlebars, which makes steering very easy. To turn
right or left, simply pull the corresponding right or left steering lever.
The sensitivity of the steering increases in proportion to the speed of the machine and the load. With an
empty machine, a light pressure on the lever is all that is needed to turn. When the machine is fully
loaded, more pressure is required.
The power trackbarrow has a maximum load capacity of 300 or 500 kg depending on the model. However,
it is advisable to assess the load and adjust it according to the ground on which the machine will be used.
It is, therefore, advisable to cover uneven or rough terrain using a low gear, and to take extra precautions.
In such situations, the machine should be kept in low gear for the entire stretch.
Avoid sharp turns and frequent changes of direction while driving on rough, hard terrains full of sharp,
uneven points with a high degree of friction.
Even though the unit has rubber tracks, remember to be careful when working in adverse weather
conditions (ice, heavy rain and snow) or on types of ground that could make the power trackbarrow
unstable.
Please note that as this is a tracked vehicle, it is subject to a considerable pitching movement when
passing over bumps, holes and steps.
When the clutch control lever is released, the machine will stop and brake automatically.
If the machine is stopped on a steep slope, a wedge should be placed against one of the tracks.
Idle Speed
Set the throttle control lever to the SLOW position to reduce stress on the engine when work is not being
performed. Lowering the engine speed will help extend the life of the engine, as well as conserve fuel and
reduce noise level.
STOP ENGINE
To stop the engine in an emergency, simply turn the engine switch to the OFF position. Under normal
conditions, use the following procedure:
1. Move the throttle lever to the SLOW position.
2. Let the engine idle for one or two minutes.
3. Turn the engine switch to the OFF position.
4. Turn the fuel valve lever to the OFF position.
Sudden stopping at a high speed under a heavy load is not recommended. Engine damage may result.
Do not move the choke control to CLOSE to stop the engine. Backfire or engine damage may occur.
8. Cleaning and maintenance
8.1. Preventive Maintenance
1. Turn off the engine and disengage all command levers. The engine must be cool.
2. Keep the engine's throttle lever in its SLOW position and remove the spark plug wire from the spark plug
and secure.
EN