Publicidad
Idiomas disponibles
Idiomas disponibles
EN
3. Inspect the general condition of the power trackbarrow. Check for loose screws, misalignment or
binding of moving parts, cracked or broken parts, and any other condition that may affect its safe
operation.
4. Use a soft brush, vacuum or compressed air to remove all contaminants from the machine. Then use
high quality light oil to lubricate all moving parts.
5. Check the spark plug wire regularly for signs of wear, and replace when needed.
Never use a "pressure washer" to clean your unit. Water can penetrate tight areas of the machine
and its transmission case and cause damage to spindles, gears, bearings, or the engine. The use of pressure
washers will result in shortened life and reduce serviceability.
8.2.
Adjusting Clutch
When the clutch begins to show wear, the handle reach will become wider, making it more difficult to
reach. Follow these steps to return the clutch lever back to its original position.
1. Loosen the jam nut by turning it counter clockwise with 10mm wrench.
2. Tighten or loosen the cable by turning the cable adjustment nut clockwise or counter clockwise with
10mm wrench until you have reached your required tightness.
3. Once tightness is set, return the jam nut against the handle to hold the cable in place.
Publicidad
