Zummo Isla Manual De Servicio página 31

The Software problems.
compressor
continues
charging air
The machine Blunt blade.
stops when
cutting
Dirty piston rod.
Faulty compressor.
Fault in the air circuit.
Waste blockage.
The pineapple is too
big.
The machine Displaced cutting
stops cutting spool.
Switch the machine Pineapple
off at the power switch container
(Fig. 3) and wait 10 detection
seconds. photocell
Switch the machine on failure
again using the power
The cutting
switch (Fig. 3).
machine does
If the problem
not cut the
continues, switch the
pineapple
machine off from the
crown
power supply (Fig.
3) and contact the
The machine
technical service.
jams when
pressing the
Contact the technical
start button
service.
Clean the piston rod.
Contact the technical
service.
Make sure the door
is properly closed by
turning the latches
all the way to the left
(Fig. 26).
Switch the machine
off at the power switch
(Fig. 3) and remove the
waste.
Pineapple label has
caused a blockage.
Switch the machine
off at the power switch
(Fig. 3) and remove the
pineapple.
Make sure the cutting
carriage is attached to
the piston rod.
Check by pulling the
carriage forwards.
The centre of view of Remove any waste or
the container door obstacles from the
sensor is dirty or centre of view of the
blocked. sensor.
Upper blade outside Set the adjustable
the processing range. blade (Fig. 9) for the
right calibre of fruit.
The door is not closed Turn the door latches
properly. all the way to the left
(Fig. 26).
The sensor does not Make sure the
detect the pineapple. pineapple is resting on
the tray.
The centre of view of Remove any waste or
the sensor is dirty or obstacles from the
blocked. centre of view of the
sensor.
31