Publicidad
Idiomas disponibles
Idiomas disponibles
Anti-clockwise
rotation
R "Reverse" for anti-
clockwise rotation.
Fig.15
Prior to starting work
Check:
- That the drill bit is properly tightened in the drill chuck,
- That the pneumatic hose is properly connected,
- That the rotation direction is adjusted with the reverse slide item 1 and the speed stage is correctly
adjusted with the speed regulator item 5 (see fig. 14 and 15).
Start the machine by actuating the valve trigger item 2 and start operating. The drill bit has to be cooled
with water in order to avoid sparks.
After finishing the work
- Release valve trigger.
- Shut the pneumatic supply, disconnect the pneumatic hose.
- Dismount the drill bit, if necessary.
Replacing the drill bit
Shut the pneumatic supply and secure against unintentional starting. Depressurize the pneumatic drill and
disconnect the pneumatic hose. Wear protective gloves when replacing the drill bit, as the drill bit and the
drill chuck can strongly heat up during longer operation. Put the drill chuck key item 7 (see fig. 16) in the
corresponding drillings of the drill chuck item 8 and undo the drill bit.
Undo
Fig.16
43
Publicidad
