MSG Equipment MS006 Manual De Usuario página 17

English
User manual
Before putting the test bench in operation, connect it to a 230V single-phase AC main. Make sure
there is an earth wire.
WARNING! The use of a Residual Current Device (RCD) I not recommended. If this is not the
case, the tripping current of the RDC should not exceed 100 mA.
5.3. Connecting a bluetooth printer to the test bench
1. Turn on the Bluetooth printer.
2. Turn on the bench and go to the "SETTINGS" menu.
3. In the "PRINTER SETTING" section, start the search for available devices by pressing the "START
SEARCH" button.
4. On completing the search for devices available in the Bluetooth range (no more than 5 meters),
select the printer and click CONNECT to confirm.
5. When connected, the TEST button is active. Then press TEST. The device will print the following
message: "MS006 ALTERNATOR TESTER READY TO WORK". Now the printer is ready for use.
6. ALTERNATOR TESTING
6.1. Installation and de-installation of the alternator
- Install the alternator on the worksite.
Figure 13. Installation of the alternator on the test bench
17