MSG Equipment MS006 Manual De Usuario página 24

English
Test bench MS006
Below the example of Valeo IST60C017 alternator is illustrated (fig. 25).
Figure 25. Alternator Valeo IST60C017 and connector terminal references
First, determine the alternator type referring to the Appendix 1. In this case, the terminal Stop
Motor Mode refers to the I-STARS alternator type.
Then we refer to the Appendix 1 to check which outputs the alternator should be connected to.
The connection chart is in the table 5 below.
connector terminal
stop motor mode
* The "- bat" terminal should be connected to the alternator housing using a self-made wire.
6.3. Alternator testing in manual mode
1. To start diagnostics, it is necessary to select the type of the alternator. Go to the "SELECT
ALTERNATOR BY TYPE" menu displayed on the start screen.
2. In the appeared window, select the nominal voltage of the tested alternator (12V or 24V) by
single clicking on the corresponding icon.
3. If it is necessary to test the alternator with the rotation speed that equals the one in the car,
use «-» and «+» buttons to set the diameter of the pulley that is identical to the diameter of the
pulley in the car. To confirm the chosen setting, press USE button.
24
Table 5 – Connection of alternator Valeo IST60C017
Alternator
+ bat
D
LIN
- bat*
Bench
diagnostic output
B+
no connection
no connection
GC
connection with the
alternator body
Cable
colour code
red
yellow