m
=
0)
m
Gu
L
Federal Communications Commission Requirements
This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant
to Part 15 of the FCC Rutes. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Warning:
To assure continued FCC compliance, the user must use the provided grounded power supply
cord and shielded interface cable with bonded ferrite cores. If BNC cable is going to be used,
use only shielded BNC (5) cable. Also, any unauthorized changes or modifications to this moni-
tor would void the user's authority to operate this device.
Note :
Fcc Class B Complied ` Up to Mode 1600x1200 at max.115.0kHz Horizontal frequency.
CE Conformity
€ € This device complies with the requirements of the EEC directive 89/336/EEC as
amended by 92/31/EEC and 93/68/EEC Art. 5 with regard to "Electromagnetic
compatibility", and 73/23/EEC as amended by 93/68/EEC Art. 13 with regard to "Safety".
Relative to Standard Value [Relative to those Exceeding Standard Value
(EMI
AAA
a
|
[ESD
|
*ea
BI
NN
ZA
| RADIATEDRF
|)
AD
83
|
7
|
| TRANSIENT FÆ >
o O O Aa
|
#B
AN
| LINE HARMONICS]
€A
| OS)
Y
#1 : Satisfies standards with no problems in performance and reliability.
#2 : Effects may appear temporarily on the screen but there will be no problem in reliability.
#3 : There is fear of the product breaking down.
#4 : If a signal cable other than that specified is used, it may be the cause of electromagnetic
wave interruption of peripheral devices.
To assure continued CE compliance the user must use the provided 1.5 m shielded
video signal cable with bonded ferrite cores at both ends of the cable.
Handle correctly in accordance with the instruction manual.
EMI : Electromagnetic Interference
ESD : Electrostatic Discharge
RF : Radio Frequency
F/B : Fast Burst
—iv—