Franke FHFB 905 5I ST Manual De Instrucciones página 20

MOUNTING THE BUILT-IN COOKTOP
Caution !
• To avoid any possible hazard, the appliance may be installed by qualifi ed personnel only.
• Panels and furniture lining of the kitchen cabinet receiving the hob must be treated with temperature resistant adhesives
100°C (otherwise they might be discoloured or deformed because of inadequate temperature resistance).
• The cooking hob is intended for building into the worktop above the kitchen element of 600 mm width or more.
• After the installation of built-in hob make sure that there is free access to the two fixing elements in front.
• Suspended kitchen elements above the cooktop must be installed at such distance to provide enough room for comfortable
working process.
• The distance between the worktop and the hood must be at least such as indicated in the instructions for installation of the
kitchen hood, but in no case it may be less than 700 mm.
• The use of hard wood decorative borders around the worktop behind the appliance is allowed, in case the minimum
distance remains as indicated on the installation illustrations.
• Minimum distance between the built-in cooktop and rear wall is indicated at the illustration for the installation of the built-in
cooktop.
Built-in induction hob
opening dimensions
Installing the foam
gasket
20
• Induction hob may be built into the 25 to 40 mm thick worktops.
• Bottom kitchen element must not have a drawer. It must be fitted with a horizontal
plate 20 mm away from the worktop bottom surface. Space between the plate and
the hob must be empty and no objects may be stored or kept there.
• Rear side of the kitchen element must also have a 50 mm high opening along the
entire width of the element, and the front part must have an opening of no less than
5 mm.
• Incorporation of the oven under the induction hob is permissible for ovens equipped
with a cooling fan.
Prior inserting the oven, it is necessary to remove the rear kitchen element panel in the
area of the oven opening.
Equally, the front part of the element must have an opening of no less than 5 mm.
Before inserting the appliance into the opening in the kitchen worktop, the supplied
foam gasket must be attached to the lower side of the glass ceramic (glass) cooking
hob.
Do not install the appliance without the foam gasket!
The gasket should be attached to the appliance in the following way:
▪ Remove the protective film from the gasket.
FHFB 905 5I ST FHFB 6421 I FLEXI
A 900mm
B 510mm
C 880mm
D 490mm
E 50mm
F 10mm
G 50mm
H 5mm
600mm
510mm
560mm
490mm
50mm
10mm
50mm
5mm