Bridge Function; Safety Switch Off - Franke FHFB 905 5I ST Manual De Instrucciones

Bridge Function

Warming Function

Safety switch off

With the bridge function two separate cooking elements /inductors with the same
diameter and equal power can be turned on at the same time and controlled with only
one operation.
Activating Bridge Function
Whether the two zones are working at a different level, whether they are at level 0:
• Simultaneously press anywhere on the slider (F) of the zones:
- 5 and 6, FHFB 905 5I ST / FHFB 6421 I FLEXI.
- 1 and 2, FHFB 6421 I FLEXI.
• Now the two areas work together, the LEDs to the right of the corresponding displays
turn on. The level is shown on the display of the control zone, in the meanwhile the
controlled zone's display turns off.
• When this function is active, you can set the timer, the LED lights on near both
displays of the zones, moreover it's not possible setting a particularly powerful
cooking function.
• If in 10 uninterrupted minutes no cookware is detected on one of the two elements,
the bridge function is automatically deactivated, the uncovered cooking element is
switched off and the covered cooking element remains as the single cooking element
switched on with the set cooking level.
Deactivating Bridge Function
The end of the Bridge Function can be done by repeating the simultaneous selection of
both cooking elements (the same as activation).
If the bridge function is deactivated while in operation, than both cooking elements go to
level "0" and can then be set again.
The warming function is used to keep cooked food warm.
Hence this function can also be used as melting or simmer function.
Activating heating function:
▪ Pressing the special function key (G) of a cooking zone activates the "melting"
function. The first LED is activated.
▪ If the special function key is pressed a second time "warming" level two is activated.
The second LED is activated.
▪ If the special function key is pressed a third time "simmering" level three is activated.
The third LED is activated.
If the special function key is pressed a fourth time the warming function ends.
Maximum continuous operation of a particular hotplate is limited, and the duration is
displayed in the above chart. When the hotplate is switched off by the safety
mechanism, the indicator displays symbols "0", or "H" in case there is any remaining
heat left.
In such cases switch the hotplate off by touching the slide sensor (F) at the start, bring
the power setting to "0".
27