Franke FHFB 905 5I ST Manual De Instrucciones página 28

Protection from overheating
Timer
28
Power setting
Hours lapse prior safety
switch off
Example:
Set the hotplate to power level 5 and leave it operate for some time. If you do not
change the above setting, the safety mechanism will switch the hotplate off after 4 hour
and a half.
Induction hotplate is also fi tted with safety device against overheating which protects
electronic parts from damages. This device operates on several levels. When
temperature of the hotplate excessively rises, it switches on two-stage fan. If this is not
enough, extra powerful heating is deactivated, and finally the safety device either
reduces the heating power of certain hotplates or turns them off completely. When the
hotplate cools off, the full power of hotplate is again available.
Use of timer facilitates cooking by setting the time of hotplate operation.
Turning timer on
• The cooktop must be turned on and the zone where you want to set the timer must
be working.
• Simultaneously press sensor (D) and (E), the timer's display shows "0.00", and the
LED to the right of the display, of the first active cooking zone from the left, lights on.
• Simultaneously press (D + E) as many times as necessary, to select the zone where
you want to set the timer. The LED lights on only for the active cooking zones.
• Within 10 seconds since pressing the (D + E) set the timer value by pressing the
sensors (D) or (E).
• The value of the timer can be displayed:
- in minutes and seconds up to 9min59sec;
- in hours and minutes up to 9h59min, in this case the word "min" is shown
under the timer's display.
Operation time can be set for each hotplate separately.
Changing preset cooking time
• Cooking time can be changed anytime during the operation.
• Simultaneously press sensor (E) and (D).
• Simultaneously press (D + E) as many times as necessary, to select the zone of
which you want to adjust the timer. The zone is identified by the lighting on of of the
LED to the right of the display.
• Press the sensors (D) or (E).
• If time is not modified in 10 seconds since pressing the sensor (D+E), the timer is
keeping the count-down before the adjusting operation.
Checking remaining cooking time
• Last set timer is always displayed, (the LED to the right of the display of the cooking
zone in question has a lighting stronger than the others).
• Simultaneously press sensor (E) and (D).
• Simultaneously press (D + E) as many times as necessary, to select the zone of
which you want to see the remaining time. The zone is identified by the lighting on of
of the LED to the right of the display.
• The timer's display will display the remaining time of the selected cooking zone.
1 2 3 4 5
6 6 5 5 4
6 7 8 9
1.5 1.5 1.5 1.5