Sunny SMART SF-RBE4886 Manual Del Usuario página 28

PROBLEM POSSIBLE CAUSE
The motor couldn't find
E1-1
its start point.
The motor signal has no
E1-2
induction.
The motor has
exceeded the maximum
E1-3
resistance level.
No EEPROM data was
read.
E2
The EEPROM data
reading error.
Hands aren't put on the
two pulse sensors
immediately after
pressing START/STOP
button.
E4
Body Fat Function
cannot receive the
signal for pulse.
NOTE: If you are unable to resolve an issue using the troubleshooting guide above, please
contact Customer Service at support@sunnyhealthfitness.com.
TROUBLESHOOTING
Check if all the cables are
well plugged in or check if
the pins on the cables are
improperly inserted. Or
check if the motor is well
connected.
Check if all the cables are
well plugged in or check if
the pins on the cables are
improperly inserted. Or
check if the motor is stuck.
Check if all the cables are
well plugged in or check if
the pins on the cables are
improperly inserted.
Check if the handle pulse
wires are well connected.
Check if the pulse is working
when not in Body Fat
Program.
27
CHECK SOLUTION
Plug in the cables again
and power on, then
press MODE and
ENTER buttons at the
same time to enter the
correction mode to
correct errors.
Plug in the cables again
or change a new motor.
Plug in the cables again
and power on, 1 second
later disconnect the
cables then re-plug in
the cables and power on
again, wait about 6
seconds let the motor
come back to its start
point, then press MODE
and ENTER buttons at
the same time to enter
the correction mode to
correct errors.
Re-connect the meter.
Power on the meter
again to re-read the
data.
Put the hands on the
two pulse sensors
immediately after
pressing START/STOP
button.
Plug in the pulse wires
again or change the
pulse wires.
Change the meter.