Then mount pulleys (47) onto the
main
support
screws (52), (49) and (48) along with
the washers (4), (10), and (50), the
guide (51) and tighten using nuts
(20) and (8) shown in fig 7.
Attach the chain (66) onto the cable
using the carabiner and the pull bar
(58), Fig.7.
Next thread cable (56), with the
pulleys in the supports (A); (B); (C);
(D); (E) and (F) using screws (52),
(55), (49) and (48) along with the
washers (4), (10), and (50), the
guide (51) and tighten using nuts
(20) and (8) shown in fig 8.
Take the chain hook (66) and join
the end of cable (56), which you
have just threaded through, with the
cable tensioner (59), Fig.8. Attach
the end of the cable (56) with the
sheet (54) fig 8.
Thread cable (57), with the pulleys in
the supports (G); (H); (I); (J); (K);
(L); (M); (N); (O) y (P) using screws
(52), (49) and (48) along with the
washers (4), (10), and (50), the
guide (51) and tighten using nuts
(20) and (8) shown in fig 9.
Take the backrest (60) and position
it on the main support (14), as
shown in Fig.9.
(14)
Fig.7
using
Now use screws (69) and washers
(10) to secure the backrest, Fig.9.
Attach the chain (67) onto the cable
using the carabiner and the handle
(70), Fig.9.
Insert the caps (41) in the leg tube
(64) and (65). Place the bottoms
foams (40) of the leg support (36).
Finally, fit the caps (42) onto the
ends of the foam covers (40), Fig.10
along with the screws (43).
Take the seat (62) and position it on
the leg support (36), Fig.10. Attach
using screws (63) and washers (10).
Fit the left and right safety covers
(68) onto the top bracket (18),
Fig.10, hand tightening screws (61)
along with the washers (10) on the
top section, Fig.10.
Also fit covers on the the bottom
bracket (1) Fig.10, using screws (61)
with washers (10), on the bottom
section, Fig.10.
Do not hesitate to get touch with the
Technical Assistance Service if you
have
any
customer services (see last page in
manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS
OF
ITS PRODUCTS WITHOUT
PRIOR NOTICE.
16
queries
by
phoning