Parkside PHKS 1350 D3 Traduccion Del Manual De Instrucciones Originale página 27

d) Store idle power tools out of the
reach of children and do not al-
low persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
e) Look after the power tool and
application tool carefully. Check
for misalignment or binding
of moving parts, breakage of
parts and any other condition
that may affect the power tool's
operation. If damaged, have the
power tool repaired before use.
Many­accidents­are­caused­by­poorly­
maintained power tools.
f) Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
g) Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking
into account the working condi-
tions and the work to be per-
formed. Use of the power tool for op-
erations different from those intended
could result in a hazardous situation.
h) Keep handles and grip surfaces
dry, clean and free from oil and
grease. Slippery handles and grip
surfaces do not permit safe operation
and­control­over­the­power­tool­in­un-
expected situations.
5) SERVICE
a) Have your power tool serviced
by a qualified repair person us-
ing only identical replacement
parts. This­will­ensure­that­the­safety­
of the power tool is maintained.
Additional instructions
a) Do not use grinding discs.
b) Select the right saw blade based
on the material you will saw.
Saw blades that are intended for cut-
ting wood or similar materials must
comply­with­EN­847-1.­Only­use­the­
saw for cutting wood, plastic and light-
weight materials
c) Only use saw blades with a
speed designation that meets
the specified speed for your ap-
pliance or higher.
d) Only use saw blades with a di-
ameter of 190 mm correspond-
ing to the markings on the saw
blade.
e) Make sure the tips of the saw
teeth do not overheat.
f) When sawing plastic, make sure
the plastic does not melt.
g) Pay attention to the maximum
cutting depth. (see technical
data)
h) When sawing, wear a dust
mask.
i) Always wear hearing protec-
tion!
j) Do not use any accessories (see
section "Spare parts/accesso-
ries") that are not recommended
by PARKSIDE. This­can­result­in­elec-
tric­shock­or­fire.
Residual risks
Even­if­properly­operating­and­handling­
this electric tool, some residual risks will
remain.­Due­to­its­construction­and­build,­
this electric tool may present the following
hazards:
a)­ Cuts
GB MT
27