Parkside PHKS 1350 D3 Traduccion Del Manual De Instrucciones Originale página 33

­Hold­the­device­firmly­with­both­
hands during the angle cut to main-
tain better control of the tool.
Adjusting the cutting depth
Illustration :
1.­ Release­the­locking­levers­(6).
2. Set the desired cutting depth on the cut-
ting­depth­scale­(4).
For a clean cut, select a cutting
depth that is approx. 3 mm
greater than the material thick-
ness.
3.­ Fix­the­locking­levers­(6).
Working instructions
Sawing, Illustration
Right angle sawing
• Hold the machine with both hands, one
hand­on­the­handle­(3)­and­the­second­
on­the­auxiliary­handle­(11).
•­ Switch­on­the­device,­see­chapter­
"Switching­on/off"
• Place the machine with the front part of
the­baseplate­(7)­on­the­workpiece.
•­ Saw­forward­with­moderate­pressure­–­
never­backward.
Mitre cuts up to 45°
• Set the desired cutting angle as de-
scribed­in­the­chapter­"Setting­the­cut-
ting­angle".
• Hold the machine with both hands, one
hand­on­the­handle­(3)­and­the­second­
on­the­auxiliary­handle­(11).
•­ Switch­on­the­device,­see­chapter­
"Switching­on/off"
• Place the machine with the front part of
the­baseplate­(7)­on­the­workpiece.
•­ Saw­forward­with­moderate­pressure­–­
never­backward.
sulting in kickback.
Selecting no-load rotation
speed
Illustration
Use­the­wheel­(22)­to­select­one­of­the­6­
no-load rotation speeds before starting the
device.
Inserting the batteries
1.­ Remove­the­screw­(25)­from­the­battery­
:
2.­ Remove­the­cover­of­the­battery­com-
3.­ Insert­the­batteries­(28)­in­the­battery­
4.­ Press­the­on/off­switch­(26)­of­the­laser.
5.­ Insert­the­cover­(27)­of­the­battery­com-
6.­ Fasten­the­cover­(27)­of­the­battery­
Switching the laser on/off
•­ Press­the­on/off­switch­(26).
•­ Press­the­on/off­switch­(26).
Moving­sideways­during­the­cut­
can cause the saw blade to jam, re-
:
­ Switch­off­the­device­and­unplug­
the plug.
Illustration :
compartment­cover­(27).
partment.
compartment.
Pay attention to the correct polari-
ty when inserting the batteries in
the­battery­compartment.­The­negative­
pole must point towards the circuit
board.
If the laser does not switch on, check
that the batteries are inserted correctly.
partment.
compartment­using­the­screw­(25).
Switch on laser, Illustration
Switch the laser off, Illustration
GB MT
:
:
33