Parkside PHKS 1350 D3 Traduccion Del Manual De Instrucciones Originale página 32

GB MT
­ If­the­function­of­the­protective­hood­
is­faulty,­do­not­put­the­device­into­
operation­and­contact­our­Service­
Centre.
Installing/changing the saw
blade
­ Switch­off­the­device­and­unplug­
the plug.
Illustration :
1.­ Place­the­device­on­the­edge­of­a­table­
so that the saw blade is freely acces-
sible­or­lay­the­device­on­its­side­with­
the saw blade pointing upwards.
Removing the saw blade
2.­ Press­and­hold­the­spindle­lock­(10).
3.­ Loosen­the­screw­(15)­with­the­hex­key­
(5).­
4.­ Remove­the­screw­(15)­and­flange­
(14).
5.­ Swivel­and­hold­back­the­guard­cover­
(16)­with­the­pull­lever­(17)­and­care-
fully­remove­the­saw­blade­(12)­down-
wards­from­the­fixed­guard­cover­(13).
Installing the saw blade
2.­ Swivel­back­the­guard­cover­(16)­with­
the­pull­lever­(17)­and­place­the­saw­
blade­(12)­from­below­into­the­fixed­
guard­cover­(13)­onto­the­spindle.
The marked running direction
on the saw blade (12) must cor-
respond with the marked run-
ning direction on the fixed guard cover
(13).
3.­ Place­the­flange­(14)­on­the­saw­blade­
(12).
4.­ Press­the­spindle­lock­(10)­and­fix­the­
saw­blade­(12)­with­the­screw­(15).­
Use­the­hex­key­(5).­
32
Make­sure­that­the­saw­blade­is­
suitable for the speed of the tool.
Connecting the dust
extraction
Illustration :
Connect­a­approved­dust­and­shavings­ex-
traction­directly­or­with­adapter­(19)­to­the­
chip­ejector­(18).
When working with materials that
produce dangerous dust, connect
the­device­to­an­appropriate,­tested­
dust­class­M­suction­device.
Mounting the rip fence
Illustration :
1.­ Loosen­the­wing­screw­(9)­for­the­par-
allel­guide­holder­(8)­and­insert­the­
parallel­guide­(20)­in­the­parallel­guide­
holder­(8).
2.­ Use­the­scale­(21)­on­the­parallel­guide­
(20)­and­the­recesses­in­the­base­plate­
(7)­to­gauge­the­desired­cutting­width.­
­ -­ Right­recess:­for­cutting­angle­setting­
0°
­ -­ Left­recess:­for­cutting­angle­setting­
45°
3.­ Tighten­the­wing­screw­(9)­of­the­paral-
lel­guide­holder­(8).
Adjusting the cutting angle
You­can­determine­the­cutting­angle­using­
the­cutting­angle­scale­(23).
Illustration :
1.­ Loosen­the­wing­screw­(24)­of­the­cut-
ting angle preselection.
2. Set the desired angle on the cutting an-
gle­scale­(23).­
3.­ Retighten­the­wing­screw­(24).