Scheppach DP16VLS Traduccion Del Manual De Instrucciones Originale página 27

Height
Base area
Weight
Laser class
Wavelength of laser
Laser output
*S6 40% = Continuous periodic operation duty with
a duty cycle of 40% (4,0 min based on a 10 minute
period)
Noise and vibration values
The total noise values determined in accordance with
EN 62841.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
Wear hearing protection.
The effects of noise can cause a loss of hearing. Total
vibration values (vector sum - three directions) deter-
mined in accordance with EN 62841.
Vibration emission value ah = 1.6 m/s
Uncertainty K = 1.5 m/s
2
The specified vibration value was established in ac-
cordance with a standardized testing method. It may
change according to how the electric equipment is
used and may exceed the specified value in exception-
al circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial as-
sessment of a harmful effect.
7. Before starting the equipment
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, store the packaging until the warranty
period has expired.
600 mm
m ATTENTION
The device and packaging materials are not toys!
290 x 190 mm
Children must not be allowed to play with plastic
13,5 kg
bags, film and small parts! There is a risk of swal-
II lowing and suffocation!
650 nm
8. Montage
< 1 mW
Column and machine foot (Fig. 3)
1.
2.
3.
70,8 dB (A)
3 dB
Table and pillar (Fig. 4)
83,8 dB (A)
1.
3 dB
2.
Machine head and pillar (Fig. 5)
1.
2.
2
Drill chuck protection with depth stop (Fig. 6)
1.
2.
3.
4.
5.
6.
The nuts (J) act to limit the depth.
Feed handles to the shaft hub (Fig. 7)
1.
www.scheppach.com
Set the machine foot (1) down on the ground or
the workbench.
Place the column (2) on the base plate so that the
holes on the column (2) align with the holes on the
base plate (1).
Screw the hexagonal screws (A) to fasten the col-
umn into the base plate and tighten them using a
hexagon spanner.
Slide the drilling table (3) onto the pillar (2). Posi-
tion the table directly above the base plate.
Install the table bolting (E) in the table unit from the
left side and tighten it.
Place the machine head (4) onto the pillar (2).
Put the spindle of the drilling machine with the ta-
ble and the base plate in the cover and fasten the
2 Allen screws (F).
Fit the chuck guard (7) on the spindle tube and
tighten the Philips screw (H).
Unfold the chuck guard (7).
Remove the nut (G) from the depth stop rod (8).
Guide the depth stop rod through the hole (I) on
the machine head (4)
Fasten the depth stop rod (8) with the nut (G) in the
hole of the chuck guard (7).
Turn the pointer on the depth stop rod (8) to the
scale on the machine head (4).
Screw the feed handles (6) tightly into the thread-
ed holes in the hub.
GB | 27