Scheppach DP16VLS Traduccion Del Manual De Instrucciones Originale página 33

15. Troubleshooting
Trouble
Quill returns too slowly or too
quickly
Chuck wiII not stay attached
to spindle. It wiII falls off when
trying to install.
Noisy operation
Wood splinters on underside
of the drill.
Workpiece torn loose from
hand.
Drill bit burns.
Drill leads off or hole is not
round.
Drill bit binds in workpiece.
Excessive drill bit run-out or
wobble.
Problem
Spring has improper tension.
Dirt, grease or oil on the tapered sur-
face of the spindle or of the chuck.
Incorrect belt tension
Dry spindle.
Loose spindle pulley.
Loose motor pulley.
No suitable material beneath work-
piece.
Workpiece not supported or clamped
properly.
Incorrect speed.
Chips not coming out of hole.
Dull drill bit.
Feed too slow.
Hard grain in wood or lengths of cut-
ting lips and/or angle not equal.
Bent drill bit.
Work piece pinching drill bit or exces-
sive feed pressure.
Improper belt tension.
Bent drill bit
Worn spindle bearings.
Drill bit not clamped centrally in
chuck.
Chuck not properly installed.
www.scheppach.com
Remedy
Adjust spring tension. See "Adjusting
the spindle retaining spring".
Use household detergent to clean the
surfaces of spindle and chuck. See
"Installing the chuck".
Adjust belt tension. See "Choosing
speed and tensioning belt".
Test spindle.
Check tightness of retaining nut on
pulley and tighten, if necessary.
Tighten set screw in motor pulley.
Use suitable material. See "Position-
ing table and workpiece".
Support workpiece or clamp it.
Change speed. See "Choosing speed
and tensioning belt".
Retract drill bit frequently to remove
chips.
Resharpen drill bit.
Increase feed rate.
Resharpen drill bit.
Replace drill bit.
Support workpiece or clamp it. See
"Positioning table and workpiece".
Adjust belt tension. See "Choosing
speed and tensioning belt".
Use a straight drill bit.
Replace bearings.
Check the centring of the drill. See
"Installing drill bits".
Install chuck properly. See "Installing
the chuck".
GB | 33