Skoda 657 054 634 Instrucciones De Montaje página 18

Reversing camera
EN
The accessories should be installed professionally. SKODA AUTO recommends to have the
installation performed at the contractual partners.
Use
The set is intended for SCALA and KAMIQ (NW) vehicles equipped with the MIB Swing,
Amundsen, Bolero, Columbus systems. Set 657 054 634 is intended for SCALA (NW1) vehicles
equipped with the PR number 3RC or 3RU. Set 658 054 634 is intended for KAMIQ (NW4)
vehicles.
Attention. The figures in the manual serve as general information for the installation.
They might be different from the installation locations of a given vehicle in some
details, based on its equipment! The manual describes installation of the reverse
camera in ŠKODA SCALA (NW1) and KAMIQ (NW4) vehicles with left-hand drive. The
installation procedure of the reversing camera on right-hand drive SCALA (NW1) and
KAMIQ (NW4) vehicles is identical, with the exception of differences shown on figures
with index B.
Attention. In places where the bundle leads over sharp edges of the body, we
recommend to wrap the bundle with additional in additional abrasion-resistant tape.
The kit includes (fig. 1)
Part name
Complete bundle of electrical wiring
Washer hose
Handle with the reversing camera
Y-bundle
Fuse, 7.5 A, MINI
Push-in clamp
2-PIN terminal block
2-PIN terminal block counterpart
Blue 12-PIN terminal block
Cable tie
Terminal block holder
6-PIN terminal block counterpart
Polyurethane foam damping
Polyurethane foam adhesive tape
Installation instructions
Attention - for Scala (NW1) vehicles only
Washer hose (B) has to be ordered from spare parts:
657 955 663 B - For vehicles with PR number 3RC
657 955 663 C - For vehicles with PR number 3RU
Special tools
Set of pin removal tools
Fish tape
18
Quantity Position
1 A
1 B
1 C
1 D
1 E
5 F
1 G
1 H
1 I
65 J
1 K
1 M
4 N
6 O