Skoda 657 054 634 Instrucciones De Montaje página 21

Fig. 12
› Wrap the bundle in suitable abrasion-resistant tape at the entry into and the exit from the
cable bushing of the 5th door electrical wiring and wrap approx. 70 cm of the bundle in soft
textile tape after the cable bushing of the 5th door electrical wiring. Snap back the unfastened
cable bushing of the 5th door electrical wiring.
Laying the bundle in the interior of the vehicle
Fig. 13
› With utmost care lift off the ceiling panel as little as necessary (it must not be damaged) so
that it is possible to pull the bundle between the ceiling and the body to the right D-pillar. Then
lead the bundle alongside the existing electrical wiring in the boot of the vehicle.
Fig. 14
› Lay the bundle (A) on the right side of the boot along the rear wheel arch and the sill of the
vehicle to the A-pillar.
Attention. Carefully align and fasten the bundle in the boot, on the wheel arch, on
the sill of the vehicle, and at the A-pillar to the existing electrical wiring bundle
using cable ties (J) spaced at 10 - 15 cm intervals.
Fig. 15A, 15B
Diagram of the electrical wiring bundle (A) in the space under the dashboard for left-hand
drive - fig. 15A - and for right-hand drive - fig. 15B -.
Fig. 16, 17, 18
› Lead the earthing lug of the brown wire to the earth bolt at the A-pillar on the right and
connect it to the earth bolt - arrow in fig. 16 -. Tighten the nut to the torque of 9 Nm.
› In case of left-hand drive, lay the bundle (A) along the A-pillar - fig. 16 - to the area of the
passenger's glove compartment - fig 17A - in the direction towards the bundle of the MIB
information electronics control unit, connect it according to the diagram and description below
- fig. 18A - then lay the bundle further to the driver's fuse box on the left.
› In case of right-hand drive, lay the bundle (A) along the A-pillar - fig. 16 - to the area of the
driver's instrument cluster- fig 17B - in the direction towards the bundle of the MIB information
electronics control unit, connect it according to the diagram and description below - fig. 18B -
then lay the bundle back to the driver's fuse box on the right.
Camera wiring harness connection to the control unit for information electronics
- Fig. 18A, 18B -.
›Disconnect the 'quadlock' terminal block from the information electronics control unit (located
in the middle of the dashboard) and connect the wires of the bundle according to the diagram
in the following way:
› Connect the white wire of the bundle to the blue terminal block (quadlock) PIN 6.
› Connect the brown wire to the blue terminal block (quadlock) PIN 12.
› Connect the blue terminal block to the corresponding terminal block (quadlock), carefully
arrange the bundle and fasten it to the existing electrical wiring bundle of the vehicle using
cable ties (J).
EN
21