Operation; Turning The Device On; Pack Or Flow Side Activation - Dentsply Sirona Calamus Dual Instrucciones De Uso

STEP-BY-STEP INSTRUCTIONS
10. Use the cannula bending tool to place a smooth radius curve on the
cannula so the cannula can extend to within 5mm of the working
length of the canal.
11. Place the cannula between the two raised bending posts. Gently bend
the cannula to the desired angle.
12. The device is now ready for operation.
Caution
Do not touch hot pluggers or hot cartridges.
6.3

OPERATION

After the unit has been set up, you are ready for operation as follows:
6.3.1

Turning the device on

Press the Power On/Off switch located on the front panel. Power is
applied and removed to the device by alternately pressing and releasing
this switch.
Buttons on the left side of the keypad are destined for Downpack,
buttons on the right are for Backfill. To change settings use up and
down buttons.
6.3.2

Pack or Flow side activation

To activate either side of the device, do one of the following: Press the
hand piece cuff or any button for the Pack or Flow side. The blue LED
indicator at the top of the device will light indicating which side is active.
(At initial power on, the Pack side of the device is turned on by default,
regardless of which side of the device was last used.) The last used
settings are retained in memory.
14/282 END-IFU-CALAMUS-DUAL-V06-WEB-EUR-Multilingual-06-2022