Publicidad
Idiomas disponibles
Idiomas disponibles
REMOTE CONTROLLER
TIMER function ---- TIMER ON
To turn on automatically
TIMER
the appliance.
When the unit is turned off, you can set the TIMER
ON.
To set the automatic start time as below:
1. Press
TIMERpul
holy first time to set
the ignition, the remote display will appear
and flash.
2. Press the or button to set the desired start time.
Each time the button is pressed, the time
increases / decreases by
half an hour between 0 and 10 hours and one half hour between 10 and 24
hours.
3. Press
TIMERpul holy a second time to confirm.
4. After setting the timer, set the necessary mode
(Cooling / Heating / Auto / Fan / Dehumidification),
l buttonMODEbutton. And set the speed of the
pressing the
fan neces
I sendFANbutton. And press or to set
sair, pr And
the required operating temperature.
CANCEL by pressing
TIMER p
TIMER function ---- TIMER OFF
To turn off automatically
TIMER
the appliance.
When the unit is turned on, you can set the TIMER
OFF.
To set the automatic shutdown time, proceed as follows: 1.
Confirm that the appliance is switched on.
ERthe first time to set it
2. Press the
i amTIM
power off button.
Press or
to set the necessary timer.
3. Press
ERthe second time for
kingTIM
confirm.
CANCEL by pressing
TIMER p
Note:All programming must be done within
5 seconds, otherwise the setting will be
canceled.
ulsante.
ulsante.
SWING function
1. Press the SWING button to activate the louver,
1.1 Press to activate the oscillation of the horizontal flaps
from top to bottom, the message will appear on the
remote display.
1.2 Press to activate the vertical flaps for swinging
from left to right, the remote display will show.
1.3 Repeat to stop the rocking motion at the current
angle.
2. If manually positioned the vertical deflectors placed
under the fins, allow to move the direct air flow to
the right or left.
3.Long press or for more than 3 seconds to select multiple
angles of the airflow direction.
Never place the Flaps manually, the delicate
mechanism could be seriously damaged!
Never put your fingers, sticks or other objects in
vents or vents. Such accidental contact
with live parts it could cause
unforeseeable damage or injury.
TURBO function
TURBO
To activate the turbo function, press the key TURBO
button, and will appear on the display. Press again to
cancel this function.
In COOL / HEAT mode, when selecting the
TURBO function, the appliance will switch to COOL mode
fast or fast HEAT and run the maximum fan speed
to blow a strong stream of air.
10
s
r pi
to
Publicidad
