Publicidad
Idiomas disponibles
Idiomas disponibles
8. Grab the Base at the Belt Path and pull
from side to side and front to back to
make sure it is installed correctly. The
Base should not move more than 2.5 cm
(1 in) in any direction.
If the Base moves too much, open the
SafeLock Belt Tensioner and remove a
little more slack from the vehicle belt,
then close and recheck. After this, if
the Base still moves too much, you
may need to try a different vehicle seat
location or installation method, or both.
9. Place the Infant Car Seat into the Base,
and listen for a CLICK. Check that the
Car Seat is installed by lifting up on the
Handle.
10. Recheck the Recline Angle to ensure it
remains in the appropriate range for the
child's weight. If not, remove the Base,
adjust the recline angle, and reinstall.
42
Installing and Removing the Infant Car Seat
Installing with Base Using Lap Belt Only
i i
o
o
a
a
CY_171_8559_A0821
1.8 - 9 kg
(4 - 20 lbs)
9 - 15.8 kg
(20 - 35 lbs)
Recline Indicator
CLICK!
Publicidad
