o This remote control can also be used for other ESOTERIC products.
a
ON/STANDBY buttons
Use these to turn the unit on or put it into standby mode.
b
Input selection buttons
Press these buttons to switch between input sources. Select the
connector that is connected to the device you want to play.
XLR
Press this to cycle through the input connectors that have
their operation mode set to XLR.
ESL-A
Press this to cycle through the input connectors that have
their operation mode set to ESLA.
RCA
Press this to cycle through the RCA connectors.
PHONO
Press this when PHONO input is selected to switch the car-
tridge type (MM/MC).
OPTION
Press this to select input connectors that have been added
using the optional board slot.
o When inputting source names, use the ESL-A and XLR but-
tons to select characters.
c
Setting adjustment (l/;) buttons
Use these to change setting values when in setting mode.
d
MENU button
Press this to enter setting mode (page 21).
e
OUTPUT button
Press this to switch which connector outputs analog audio
(page 20).
Press this when in setting mode to complete changing settings.
f
VOLUME (+/−) buttons
Use these to adjust the volume. Press the + button to increase
the volume and the − button to decrease it.
o The VOLUME (+/−) buttons will not affect input sources set to
THRU> (page 26).
g
MUTE button
Press this button to temporarily mute the sound. Press this again
to restore the volume setting (page 19).
o When muted, "MUTE" blinks on the screen.
h
Mode selection buttons
Press the SACD button to put the remote control into SACD
mode, enabling use of the PLAYER buttons to control the SACD
player/transport.
Press the NET button to put the remote control into NET mode,
enabling use of the PLAYER buttons to control the network
player.
After switching modes, the mode will be retained until the
SACD/NET button is pressed again or the batteries are replaced.
i
DIMMER button
Use this to adjust the brightness of the main unit's display
(page 20).
j
PLAYER buttons
Use these to control an ESOTERIC player.
17