Publicidad
Idiomas disponibles
Idiomas disponibles
A
Analog input (INPUTS) connectors
Connect the analog output connectors of Super Audio CD play-
ers, DVD players, cassette decks, tuners and other equipment to
these connectors.
Connect the R connector of a pair on this unit to the right (R)
connector of an output device and the L connector of the same
pair on this unit to the left (L) connector of the output device.
Use commercially-available cables for connections.
XLR: balanced XLR cables
Insert the balanced XLR plugs until the connector levers lock.
Press these levers and pull the plugs out to disconnect.
RCA, PHONO: RCA cables
Connect the white pin plugs to the white (L) connectors and
connect the red pin plugs to the red (R) connectors.
Connecting record players
This unit has a built-in phono equalizer. When connecting a
record player, use the PHONO connectors.
o Always connect the record player's ground to the SIGNAL
GND grounding terminal on this unit.
o Set the cartridge type being used with the PHONO> setting
(page 26).
B
SIGNAL GND grounding terminal
Using a commercially-available sheathed wire to connect this
to the grounding terminal of a Super Audio CD player, power
amplifier or other device might improve the audio quality.
o This is not a safety grounding terminal.
C
Analog output (PRE OUT) connectors
These output 2 channels of analog audio.
To use this unit as a preamp, see "Connections for use as a pre-
amp" on page 11.
Connect the R connector of a pair on this unit to the right (R)
connector of an input device and the L connector of the same
pair on this unit to the left (L) connector of the input device.
Use commercially-available cables for connections.
XLR: balanced XLR cables
Insert the balanced XLR plugs into the connectors until they
lock.
ESL-A: balanced XLR cables
Use commercially-available shielded cables (page 12).
D
Remote control input (RS-232C) connector
This control connector is for use by professionals (custom
installers).
E
TRIGGER IN/OUT connectors
Use these connectors to control power from an external source.
Do not connect anything to these connectors when not using
them.
F
Optional board slot
This slot is for installing optional boards that are sold separately.
G
DC IN connector
Use this connector to connect an external power supply unit.
Do not connect any equipment that has not been specified by
ESOTERIC.
H
AC power inlet (~IN)
Connect the supplied power cord to this AC inlet.
After completing all other connections, plug the power plug
into a power outlet.
Use only a genuine ESOTERIC power cord.
V
Use of other power cords could result in fire
or electric shock.
Disconnect the power plug from the outlet if
V
you will not use the unit for a long time.
9
Publicidad
