Hach 8310 Manual Del Usuario página 4

Specification
Accuracy
Measurement range
Temperature
response
Maximum
temperature
Maximum pressure
Sample connection
Material
Maximum temperature
Maximum pressure
Sensor connection
Sample connection
Material
Maximum temperature
Maximum pressure
Sensor connection
Sample connection
Section 2 General information
In no event will the manufacturer be liable for damages resulting from any improper use of product or
failure to comply with the instructions in the manual. The manufacturer reserves the right to make
changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.
2.1 Safety information
The manufacturer is not responsible for any damages due to misapplication or misuse of this product
including, without limitation, direct, incidental and consequential damages, and disclaims such
damages to the full extent permitted under applicable law. The user is solely responsible to identify
critical application risks and install appropriate mechanisms to protect processes during a possible
equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this
equipment in any manner other than that specified in this manual.
4 English
8315
< 2%
-1
0.01—200 μS.cm 0.1 μS—2 mS.cm
< 30 seconds
150 °C (302 °F) 150 °C (302 °F)
25 bars (363 psi) 25 bars (363 psi)
¾-inch NPT
Table 2 Flow chambers
60 °C (140 °F) at 2 bar (29 psi)
15 bar (217.5 psi) at 25 °C (77 °F)
8316
< 2%
-1
1 μS—20 mS.cm
< 30 seconds < 30 seconds
150 °C (302 °F)
25 bars (363 psi)
¾-inch NPT ¾-inch NPT
08313=A=0001
PVC
¾-inch NPT
¾-inch NPT
08394=A=8200
316L stainless steel
150 °C (302 °F)
25 bar (362.6 psi)
Tri-Clamp 2 inch
¼-inch NPT
8317 8394
< 2% < 2%
-1
0.01—200 μS.cm
< 30 seconds
150 °C (302 °F)
25 bars (363 psi)
Tri-Clamp 1½ or 2 inch
08318=A=0001
316L stainless steel
150 °C (302 °F)
25 bar (362.6 psi)
¾-inch NPT
¼-inch NPT
08394=A=8150
316L stainless steel
150 °C (302 °F)
25 bar (362.6 psi)
Tri-Clamp 1½ inch
¼-inch NPT
-1