Publicidad
Idiomas disponibles
Idiomas disponibles
HID207
User Manual
Initial Start Up
1. Remove panels: top and left side.
2. Turn water on, observe that water enters the water
reservoir, fills and then shuts off. Check for leaks.
Repair any leaks before going any further.
3. Plug in ice machine into it's own circuit; with no
other appliances. On the Indicator Light Panel the
Power light will show green.
4. Locate the External Button on the Splash Panel
and hold down for 3 seconds. Then on the
Indicator Light Panel, the Status light will show
green and the ice making process will start. Warm
air will blow out the right side.
Note: If the ice making process doesn't start, remove
the right side panel, remove the Control Box cover
and check for any errors being displayed. See page
15 for details..
5. Within minutes ice will begin to fall into the
dispensing bin. Check ice dispensing by holding
a container in front of the Touch Free ice sensor
(just below the ice delivery spout) or push the
ice vend button on model HID207ABX. The ice
dispense indicator light will glow and ice should
flow from the spout when a container is present,
and stop dispensing when the container is
removed.
6. Check water dispensing by holding a container
in front of the Touch Free water sensor or push
the water dispense button on model HID207ABX.
The water indicator will glow and water will flow
when a container is present and stop when it is
removed.
7. Press and hold the External Button for 3 seconds
to stop the ice making process.
POWER
STATUS
BIN FULL
November 2023
Page 9
8. Wait about a minute for the ice making process to
finish, then unplug or disconnect electrical power.
9. Scoop out any ice in the bin and sanitize the
interior of the ice storage bin by wiping it with a
locally approved sanitizer or a mixture of 2 oz of
NuCalgon and 1.25 gal of 95-115 degrees water,
allow to air dry.
10. Reconnect electrical power.
11. Press and hold the External Button for 3 seconds
to start the ice making process.
12. Replace all covers and panels.
13. Give the owner/user the user manual, instruct
him/her in the operation and maintenance
requirements of the unit. Make sure they know
who to call for service.
14. Have the customer fill out the Customer
Evaluation and Warranty Registration form,
and mail it in to Scotsman or register the unit at
Scotsman's website (www.scotsman-ice.com) or
scan the QR code behind Drip Tray.
UV
External
Button
CLEAN
Publicidad
