Publicidad
Idiomas disponibles
Idiomas disponibles
HID207
User Manual
Sanitize Water System
Perform after scale removal to complete the
Water System Cleaning process.
1. Create a solution of sanitizer.
2. Mix 4 oz/118ml of NuCalgon IMS and 2.5 gal/9.5L
of (90
F/32
C to 110
0
0
create a 200 ppm solution.
3. Rotate the reservoir's water shut off knob to shut
the water supply OFF. If water reservoir cover has
been placed on reservoir, remove it.
4. Pour the sanitizing solution into the reservoir until
it is full to but not over the overflow point (about 8
oz) and wait 2 minutes.
5. Press the On button to turn the ice machine ON.
Moving parts hazard.
Risk of personal injury.
6. Operate the machine for at least 15 minutes,
adding sanitizer to the reservoir as needed to
keep it at least half full, and then push and release
the Off button to shut it OFF.
7. Remove the ice sweep.
F/43
C ) potable water to
0
0
8. Wash the reservoir cover, ice sweep, breaker
and the inside of the ice chute with the sanitizer
solution.
Caution: Do not allow sanitizer to contact the
bearing.
9. Return the ice sweep and reservoir cover to their
normal positions.
10. Drain the solution from the system by pulling the
reservoir's drain plug.
11. Return plug when drained.
12. Rinse bin liner with clean water. Be sure all ice
has been melted.
Note: Only add 16 oz or 1/2 liter water to the bin at a
time, as excess water will drain out the spout.
13. Remove agitator bar and dispense rotor.
14. Remove ice and water dispense chutes.
15. Thoroughly wash dispense chutes agitator bar,
dispense rotor and all bin interior surface areas
including bin cover and any other areas that may
contact the ice with the sanitizer solution.
16. Rinse with clean water.
17. Return dispense chutes, agitator bar and dispense
rotor to their original positions.
18. Rotate water shut off knob to turn the water supply
ON.
19. Push and release the On button to restart ice
making.
20. Return the dispense bin cover to the machine and
secure with the original screws.
21. Return all panels to their normal positions and
secure with the original screws.
November 2023
Page 20
Publicidad
