Rothenberger ROCAM mini HD AMPShare Instrucciones De Uso página 25

RO BP 18V ProCORE AMPShare
LED
5× continuous green light
4× continuous green light
3× continuous green light
2× continuous green light
1× continuous green light
1× flashing green light
Recommendations for Optimal Handling of the Battery:
Protect the battery against moisture and water.
Only store the battery within a temperature range of −20 to 50 C. Do not leave the battery in
your car in the summer, for example.
Occasionally clean the ventilation slots on the battery using a soft brush that is clean and dry.
A significantly reduced operating time after charging indicates that the battery has deteriorated
and must be replaced.
Follow the instructions on correct disposal!
3.4 Installation ROCAM mini HD AMPShare Haspel or Modul ROLOC Plus AMPShare
Only one device should be connected to the unit at a time. Always make sure the unit is
off when installing or removing imagers or other accessories!
The plug of the camera cable must be connected to the monitor unit in order to use the ROCAM
mini HD AMPShare reel or ROLOC Plus AMPShare. To secure connector, make sure the key
and slot are properly aligned. Once they are aligned, hand-tighten the knurled nut to hold the
connection in place.
3.5 Working with the device
Wear protective clothing! Always stand next to the reel cable!
 Push reel cable (4) with bending spring (3) from the holder (8).
Caution: Check for cleanliness and damage!
 If necessary, additional accessories can be attached to camera. When using pipe diameters
greater than 70 mm, always use guide body!
 Clean the pipe system before inspection.
 Turn the device on with the Power-button (5.1) located on the monitor (5).
Excessive pressure on the touch screen may damage the monitor unit!
 Remove the camera head (1) from the holder (8) and pull the cable (4) from the reel (6). The
cable is rigid and is under mechanical stress. Therefore, hold it firmly when unwinding from
the reel.
 Guide the camera head (1) into the pipe system and carefully push it with the cable (4).
Do not pull the cable (4) over sharp edges, and do not bend it!! Check the camera cable
before each use for damage!
While it is being pushed, the cable (4) may loop: Breakage may result!
With self-leveling activated, the camera image is always upright while advancing through multi-
ple pipe bends.
 After work is finished, pull the cable (4) out of the pipe and push it directly onto the reel (6).
Remove coarse dirt and water with a rag while winding cable on reel.
RO BP 18V AMPShare
Capacity LED
80–100 % 3× continuous green light
60–80 % 2× continuous green light
40–60 % 1× continuous green light
20–40 % 1× flashing green light
5–20 %
0–5 %
ENGLISH
Capacity
60–100 %
30–60 %
5–30 %
0–5 %
21